IBM Sterling B2B: Instalação para Node secundário de cluster
Para o node secundário (node 2) ou superior.
Instalação
Follow the steps in IBM Sterling B2B: Instalação usando Installation Manager - Node 1. The only difference you MUST mark on the Question “This installation if for a cluster node 2 or higher” in the Installation Manager and specify the number of node.
Post install
Adding host[port] from all the nodes to jgroups_cluster.property.in
Edit file <si_install_directory>/properties/jgroups_cluster.property.in and add:
- on Node 1:
initial_hosts=node1_ipaddress[port1],node2_ipaddress[port2]
- on Node 2
initial_hosts=node2_ipaddress[port2],node1_ipaddress[port1]
Run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
(Optional) Updating the sandbox.cfg file for an IPv4 address
Edit file <si_install_directory>/properties/sandbox.cfg and ADD:
IPV4STACK=true
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
(Optional) Configuring shared file systems as document storage
Sterling B2B Integrator handled Documents stored in Database or on File System.
To configure the shared file systems as document storage, change on file <si_install_directory>/properties/sandbox.cfg and change:
DOC_PAYLOAD_DIR=/SI_Shared_Area
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
This will update document_dir and RESTORE_DOCUMENT_DIR properties of the jdbc.properties.in file.