IBM Sterling B2B: Instalação para Node secundário de cluster
Para o node secundário (node 2) ou superior.
Instalação
Follow the steps in IBM Sterling B2B: Instalação usando Installation Manager - Node 1. The only difference you MUST mark on the Question “This installation if for a cluster node 2 or higher” in the Installation Manager and specify the number of node.
Post install
Adding host[port] from all the nodes to jgroups_cluster.property.in
Edit file <si_install_directory>/properties/jgroups_cluster.property.in and add:
- on Node 1:
initial_hosts=node1_ipaddress[port1],node2_ipaddress[port2]
- on Node 2
initial_hosts=node2_ipaddress[port2],node1_ipaddress[port1]
Run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
Post Install - Optional
(Optional) Updating the sandbox.cfg file for an IPv4 address
Edit file <si_install_directory>/properties/sandbox.cfg and ADD:
IPV4STACK=true
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
Sterling B2B Integrator handled Documents stored in Database or on File System.
To configure the shared file systems as document storage, change on file <si_install_directory>/properties/sandbox.cfg and change:
DOC_PAYLOAD_DIR=/SI_Shared_Area
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
This will update document_dir and RESTORE_DOCUMENT_DIR properties of the jdbc.properties.in file.