IBM Sterling B2B: Instalação para Node secundário de cluster: Difference between revisions
| Line 10: | Line 10: | ||
= Post install = | = Post install = | ||
== Adding host[port] from all the nodes to jgroups_cluster.property.in == | == Adding host[port] from all the nodes to jgroups_cluster.property.in == | ||
| Line 41: | Line 30: | ||
==Configuring shared file systems as document storage== | == (Optional) Updating the sandbox.cfg file for an IPv4 address == | ||
Edit file '''<si_install_directory>/properties/sandbox.cfg''' and ADD: | |||
IPV4STACK=true | |||
After run setupfiles.sh to update config | |||
cd '''<si_install_directory>/bin/''' | |||
./setupfiles.sh | |||
== (Optional) Configuring shared file systems as document storage== | |||
Sterling B2B Integrator handled Documents stored in Database or on File System. | Sterling B2B Integrator handled Documents stored in Database or on File System. | ||
Revision as of 14:33, 9 September 2020
Para o node secundário (node 2) ou superior.
Instalação
Follow the steps in IBM Sterling B2B: Instalação usando Installation Manager - Node 1. The only difference you MUST mark on the Question “This installation if for a cluster node 2 or higher” in the Installation Manager and specify the number of node.
Post install
Adding host[port] from all the nodes to jgroups_cluster.property.in
Edit file <si_install_directory>/properties/jgroups_cluster.property.in and add:
- on Node 1:
initial_hosts=node1_ipaddress[port1],node2_ipaddress[port2]
- on Node 2
initial_hosts=node2_ipaddress[port2],node1_ipaddress[port1]
Run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
(Optional) Updating the sandbox.cfg file for an IPv4 address
Edit file <si_install_directory>/properties/sandbox.cfg and ADD:
IPV4STACK=true
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
Sterling B2B Integrator handled Documents stored in Database or on File System.
To configure the shared file systems as document storage, change on file <si_install_directory>/properties/sandbox.cfg and change:
DOC_PAYLOAD_DIR=/SI_Shared_Area
After run setupfiles.sh to update config
cd <si_install_directory>/bin/ ./setupfiles.sh
This will update document_dir and RESTORE_DOCUMENT_DIR properties of the jdbc.properties.in file.